|
 The first DC spherical motor pump for directconnection to photovoltaic panels with automatic performance optimization using MPP technology (Maximum Power Point tracking)
Application
The Ecocirc solar pump can be used wherever a highly efficient circulation pump is needed without a direct connection to AC power. It can be connected directly to a photovoltaic panel and is characterized by its small size, high efficiency, very low power
consumption and its MPP tracking. The shaftless spherical motor technology enables a long, maintenance free and quiet service life. Areas of application are thermal solar systems for single family homes.
Design
The principle of the spherical motor, which was invented by Laing, is fundamentally different from conventional canned motor pumps. The only moving part in a spherical motor is a hemispherical rotor/impeller unit, which sits on an ultra-hard, wear-resistant ceramic ball. There are no conventional shaft bearings or seals. This rules out, in effect, the possibility of play in the bearings and the increase in noise associated with it. These pumps are particularly robust and give exceptionally long service. The self-realigning bearing is lubricated and cooled by the media. Maintenance is not necessary under normal conditions and even after lengthy shutdown periods a reliable start-up is virtually guaranteed. The parts exposed to the fluid are completely corrosion resistant.
Soft start-up
The pump has been programmed for a soft start-up. When the photovoltaic panel provides sufficient power, the pump first goes through the alignment phase, turning the rotor into the position required for start-up. Then the processor waits until the built-in capacitor has recharged sufficiently. This enables a start-up with minimal power (less than one Watt). Cycling due to unsuccessful starting attempts is minimized. Even after prolonged shutdown, the pump will start reliably.
Automatic performance optimization – MPP tracking
The Ecocirc DC pumps are the first and only spherical motor pumps with self-optimizing software (see diagram). Every three seconds, the processor will modify its operating point on the voltage-current curve of the PV panel to find the point of maximum performance. This is called the “Maximum Power Point” (MPP).
At this point, the pump achieves the maximum rpm and therefore the maximum performance. There is no need for a separate performance adaptation, the pump will always find its best operating point under any given light and temperature conditions by itself.
Download Brochure
|
| |
| |
Pump Curve |
Exploded View |
 
|
| |
Technical Data
- Motor design: Electronically commutated, spherical motor
- Voltage Range: 8 to 24 V DC
- Maximum system pressure: 150 PSI (brass housing)
- Maximum Temperature: 230°F (brass)
- Acceptable media: Domestic hot water, heating water, water/Glycol mixtures
|
Possible Applications
- Solar Systems
- Computer Cooling Systems
- Circulating systems for Homes, RV's and boats
- Engine block circulating systems
- Juice Machines
- Aquariums and ponds
- Oxygen generating systems
- Vending Machines
- Water fountains
- Process temperature control
- Remote area fluid handling
|
|
Our Free Webinars can be attended if you have a phone and an internet connection
This an opportunity and ask questions on how solar can work for you
Current webinar - Designing solar heating for your home, business, garage, shed , warehouse, hangar , cabin, greenhouse and expected payback
Lasts about 1 hour with a 15 minute question period
Upcoming Webinars
Solar Heating your Swimming Pool for FREE
What makes sense in Solar - the truth about solar voltaic, wind turbines solar water heating, led lights and geothermal
Sign up for Newsletter below and get registered |
Ready to order or have some questions?
Simply pickup the phone and call 1 306 244 8808 or if you would like us to contact you, simply email us at info@wsetech.com
Barry ext 242
Brayden ext 239
Lee kkkkk ext 232
Become A Dealer
Become involved with a dynamic company and dynamic industry that will see exponential growth and opportunities over the next 20 years. The key is to get in NOW before it is too late.
Linda 1 306 244 8808 ext 226 or Email
Information about become a dealer click here
WSE Technologies
303 - 47Str. E
Saskatoon
Saskatchewan
Canada
S7K 5H2
Ph: 1 306 244 8808
Fax: 1 306 244-9970
We accept Visa and Master card.
|
